Wrong clearances are one of the most common causes of rework on pivot doors. Too tight and the door rubs; too loose and it looks sloppy and lets wind and dust in. These are the gaps we recommend for doors with the Marix floor closer.

Wood pivot door gaps

Glass pivot doors

  • 3/8″ (10 mm) at the floor
  • 3/16″ (5 mm) at the top and on each side

Wood pivot doors

  • 1/4″ (6 mm) at the top and at the bottom
  • 5/32″ (4 mm) on each side
  • In total: about 1/2″ (12 mm) less than the opening height and 5/16″ (8 mm) less than the width

Measure the opening first

Measure the width at the bottom, middle and top, and the height on the left, center and right. Always use the smallest number to size the door.

Measure the opening at 3 points

Which closer?

Door weight (door + glass/panel + hardware)Marix model
up to 110 lb110 lb
up to 260 lb260 lb
up to 330 lb330 lb
up to 550 lb550 lb

FAQ

Why does a pivot door need a bigger gap at the floor?

The closer plate and the floor finish need room, and the door must clear rugs and small floor irregularities.

What happens if the gap is too small?

The door rubs, the closer works harder and the alignment wears out faster.

Do aluminum doors use the same gaps?

Follow the frame manufacturer’s gaps for aluminum doors. For questions, contact us.