Most pivot door problems are not the closer itself: they come from alignment or from tightening the closer with the door open. Here are the most common cases and how to fix them.
The door stops short of the jamb
Cause: the closer was tightened slightly out of line.
- Loosen the 4 screws (if the door is in the way, loosen the top pivot).
- Align the closer.
- Turn it about 1/16″ (1–2 mm) toward the closing side.
- Re-tighten all 4 screws.
The door opens instead of closing, or stays open
Cause: the closer was fastened with the door open, or the top pivot is not lined up with the closer. Take off the top hardware, re-seat the door in the closed position, check the plumb and fasten again.
Always tighten with the door closed
The final tightening of the 4 screws is always done with the door closed, in a cross pattern, a little at a time.
Glass doors: use a flush lock
A lock without a flange won’t block the swing and makes alignment easier.
More cases: installation problems and solutions.
FAQ
Do I need a new closer if the door doesn’t close?
Usually not. Check alignment and tightening first.
Does the Marix closer need lubrication?
No. It is fully shielded and maintenance-free.
Is there a warranty?
Yes, 5 years.